JAOW™ | Enhanced Control Grip (PTR Jack & SCT HammerHead Compatible)

Precision Fit Upgrade for the PTR Jack & SCT HammerHead Platform

The JAOW™ Grip is a direct-fit ergonomic upgrade engineered specifically for the PTR Industries Jack & Shark Coast Tactical HammerHead platform.

No permanent modification required. The JAOW installs using the factory grip interface and hardware — no cutting or drilling required.

Design

The factory grip works. The JAOW refines it.

• Optimized grip angle
• Clean, modern profile
• No finger grooves
• Manufactured from PA-11, Made in the USA
• Lightweight, rigid nylon construction

Tested Platform

The JAOW has been test-installed and function-tested exclusively on the PTR Industries Jack and SCT HammerHead platform. It has not been tested on any other platforms. Compatibility outside of the PTR Jack & SCT HammerHead is not guaranteed.

Fitment Note

Due to normal manufacturing tolerances in the printing process, fitment may vary slightly from one grip to another. Some grips may require more force during installation than others, and this is considered normal.

The grip is intentionally designed with a snug, secure fit on the action flange to help minimize movement once installed. As a result, firm, even pressure may be required to fully seat the grip. Every grip is individually test-fit on an actual PTR Jack to verify proper fitment and screw alignment before shipment.

Because slight dimensional variations can exist between individual action flanges, minor fitting may occasionally be required. If the fit is excessively tight, a small amount of material can be carefully remove material from the inside right and left wall of the grip flange using fine-grit sandpaper until the desired fit is achieved. Remove only small amounts at a time and test fit frequently.

Finish Notice

Each grip is dyed black after manufacturing. Due to the dyeing process, slight color variation may occur. Some units may exhibit a subtle blue hue under certain lighting conditions and may not appear as a true deep black.

Liability & Installation Notice

This product is an aftermarket accessory intended for use on the PTR Industries Jack & SCT HammerHead platform only.

The purchaser assumes all responsibility for proper installation, safe handling, and compliance with all applicable laws and regulations. Atlas Defense Co. is not responsible for misuse, improper installation, or modification of this product.